Proel FLASH12PV2 Manual do Utilizador descarregar pdf (Página 17)

CE CONFORMITY

• Proel products comply with direcve 2004/108/EC (EMC), as stated in EN 55103-1 and EN 55103-2 standards and with direcve 2006/95/CE

(LVD), as stated in EN 60065 standard.

• Under the EM disturbance, the rao of signal-noise will be changed above 10dB.

PACKAGING, SHIPPING AND COMPLAINT

• This unit package has been submied to ISTA 1A integrity tests. We suggest you control the unit condions immediately aer unpacking it.

• If any damage is found, immediately advise the dealer. Keep all unit packaging parts to allow inspecon.

• Proel is not responsible for any damage that occurs during shipment.

• Products are sold “delivered ex warehouse” and shipment is at charge and risk of the buyer.

• Possible damages to unit should be immediately noed to forwarder. Each complaint for package tampered with should be done within eight

days from product receipt.

WARRANTY AND PRODUCTS RETURN

• Proel products have operang warranty and comply their specicaons, as stated by manufacturer.

• Proel warrants all materials, workmanship and proper operaon of this product for a period of two years from the original date of purchase. If

any defects are found in the materials or workmanship or if the product fails to funcon properly during the applicable warranty period, the owner

should inform about these defects the dealer or the distributor, providing receipt or invoice of date of purchase and defect detailed descripon.

This warranty does not extend to damage resulng from improper installaon, misuse, neglect or abuse. Proel S.p.A. will verify damage on returned

units, and when the unit has been properly used and warranty is sll valid, then the unit will be replaced or repaired. Proel S.p.A. is not responsible

for any "direct damage" or "indirect damage" caused by product defecveness.

INSTALLATION AND DISCLAIMER

• Proel products have been expressly designed for audio applicaon, with signals in audio range (20Hz to 20kHz). Proel has no liability for damages

caused in case of lack of maintenance, modicaons, improper use or improper installaon non-applying safety instrucons.

• The installaon of these speakers is provided for indoors, in case of use outdoors be sure that the speakers are installed correctly in a safe

locaon protected from wind, rain and humidity. To avoid performance deterioraon of mechanical, acouscs and electrical parts is not advisable

to leave these speakers exposed outdoors for a long period of me, so we suggest a temporary installaon for the limited sound events.

• The installaon of these speakers is provided for oor or by means of specic stands able to support their weight. Therefore avoid installaon

on unstable elements such as: furniture, chairs and vibrant surfaces as stages or other speakers without appropriate x point specically designed

to avoid speaker movement. Then avoid the use of inadequate supports, we suggest to use PROEL stands and accessories only.

• In case of the speakers are provided of rigging points: DO NOT SUSPEND THE SPEAKERS FROM THE HANDLES, use exclusively these rigging points.

Consult professional rigger or structural engineers prior to suspending loudspeakers from a structure not intended for that use. Always know the

working load limit of the structure supporng the loudspeakers. Always make sure that the rigging hardware minimum rang is at least ve mes

the actual load, speakers and rigging hardware.

• In case of suspended installaons of acve loudspeakers where is not possible to turn on and o the speakers from their appropriate switches,

we recommend to install switches on the mains lines, for this purpose consult an expert electrician for the exact dimension of wiring.

• Locate the speakers as far away as possible from radio or television receivers or other sensive equipment. These speakers have a strong

magnec eld which can induce hum and noise into unshielded devices that are located nearby with consequent deterioraon of recepon of

image and sound.

• Proel S.p.A. reserves the right to change these specicaons at any me without noce.

• Proel S.p.A. declines any liability for damages to objects or persons caused by lacks of maintenance, improper use, installaon not performed

with safety precauons and at the state of the art.

POWER SUPPLY AND MAINTENANCE

• Clean only with dry cloth.

• Check periodically that the slots for its proper venlaon and heang dissipaon are not obstructed by dust, remove the dust using a dry brush

or a compressed air gun.

• The amplied loudspeakers of Proel have been designed with CLASS I construcon and must be connected always to a mains socket outlet with

a protecve earth connecon (the third grounding prong).

• Before connecng the product to the mains outlet make certain that the mains line voltage matches that shown on the rear of the product, a

tolerance of up to ±10% is acceptable.

• Inside the amplied loudspeakers are present special safety devices such as:

ü Transformer and amplier over-heang protecon.

ü Protecon against excessive power applied at each speaker.

•

THE REPLACEMENT OF FUSES INSIDE THE APPARATUS MUST BE MADE ONLY BY QUALIFIED PERSONNEL.

•

CHECK THE CONDITION OF THE PROTECTION FUSE, ACCESSIBLE OUTWARD, ONLY WITH THE APPARATUS SWITCHED OFF AND DISCONNECTED

FROM THE MAINS LINE OUTLET.

•

REPLACE THE PROTECTION FUSE ONLY WITH SAME TYPE AS SHOWN ON THE PRODUCT.

•

IF AFTER THE SUBSTITUTION, THE FUSE INTERRUPTS AGAIN THE APPARATUS WORKING, DO NOT TRY AGAIN THEN CONTACT THE PROEL

SERVICE CENTRE.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Comentários a estes Manuais

Sem comentários

Proel FLASH12PV2 Manual do Utilizador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Acústica Proel FLASH12PV2